ЕС7978.0007 Serial port board

This board based on 2 National Semiconductor's INS8250 ics.


Comments

Post a Comment

Popular posts from this blog

YD-RP2040 Module

Image
I want to tell you about the rather inexpensive YD-RP2040 module and show some examples of working with it. Photos and Schematics Top view: Bottom view: The module’s electrical schematic can be found here https://github.com/initdc/YD-RP2040/blob/master/YD-2040-2022-V1.1-SCH.pdf Differences from the original Raspberry Pi Pico This board has several key hardware differences from the standard Raspberry Pi Pico module. Key changes:  - Flash memory : The module can be fitted with a larger Flash memory capacity — 4MB (32Mbit) or even 16MB (128Mbit) instead of the 2MB in the original.  - Voltage regulator : The DC-DC step-down converter is replaced with a cheaper and less efficient linear regulator. This has freed up pin GPIO23, which was used to control the DC-DC converter in the original Pico.  - RGB LED : A WS2812 addressable LED (Neo-pixel) is connected to the freed GPIO23 pin. Unlike the original Pico, this board has two additional buttons:  - RESET — for a ...
Read more

How to Add CH32V Support to PlatformIO

Image
CH32V are quite cheap RISC-V architecture microcontrollers from WinChipHead (Nanjing Qinheng Microelectronics). There is also CH32F — these are microcontrollers based on the ARM architecture. To get started, we will need two things: A CR-CH32VXX development board (devboard) with a CH32V003 — which is one of the cheapest microcontrollers. And a WCH-LinkE — a programmer for the CH32V. You can find standard WCH-Link programmers on sale, but they are not suitable for the CH32V00x series because it uses a single-wire programming and debugging protocol. And this is only supported by the more expensive WCH-LinkE. By the way, there are projects that turn an RP2040 into a similar programmer, but the official utilities (MounRiver Studio) do not support anything other than WCH-Link. However, I don’t use the official IDE anyway. Therefore, I will probably try doing this and describe the process in the near future. Why do I use PlatformIO instead of MounRiver Studio? On the one hand, Mou...
Read more

Orange Pi Zero 3 - exploring GPIO

Image
GPIO (General-Purpose Input/Output, or General-Purpose Pins) is a fundamental concept that came into the world of powerful SoCs (System-on-a-Chip) directly from the realm of microcontrollers. It is the main bridge for your single-board computer to interact with simple external devices, in addition to more complex hardware interfaces (such as I2C, SPI, UART, or I2S). While specialized protocols transmit data streams, GPIO allows you to work at the lowest level -controlling individual digital signals. With each pin you can: Read the state (input): For example, check if a button is pressed, or if the signal is “1” or “0”. Control the state (output): For example, turn on an LED, activate a relay, or send a signal to another component. In this article, I want to provide a quick overview of the methods for working with GPIO on the Orange Pi Zero 3 (which is based on the Allwinner H618 SoC ). Of course, these methods are not unique and can be applied to other single-board computers a...
Read more